2014-2019 Hiace · Service Manual BRAKE

REMOVAL

Removal / installation · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


4. REMOVE STEERING WHEEL ASSEMBLY
(Click here)

5. REMOVE NO. 2 STEERING COLUMN LOWER COVER (w/ Smart Entry and Start System)

  1. C299749
    Detach the 4 claws and remove the No. 2 steering column lower cover.


6. REMOVE LOWER STEERING COLUMN COVER

HINT:
Adjust the position of the steering tilt mechanism when performing the procedure.

  1. C299615
    Remove the 2 "TORX" screws (T25) from the steering column lower cover.

  1. C299580
    Push the steering column lower cover inward on both sides to detach the 2 claws.

  1. C299748
    Detach the 2 claws and remove the steering column lower cover.


7. REMOVE UPPER STEERING COLUMN COVER

  1. C299599E01
    Remove the steering column upper cover from the steering column assembly.
    Text in Illustration 
    *a
    Front of Vehicle
    *b
    Raise the backside of the steering column upper cover
    *c
    Pull diagonally backwards so that the claw of the steering column upper cover does not break

    NOTICE:
    If the steering column upper cover is removed by pulling it directly upwards, the claw may become damaged.


8. REMOVE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

NOTICE:
  1. Do not replace the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.
  2. Do not rotate the spiral with sensor cable sub-assembly with the battery connected and the ignition switch on.

  1. C320494E01
    Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral with sensor cable sub-assembly.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    Text in Illustration 
    *1
    Slider

  1. Disconnect each connector from the spiral with sensor cable sub-assembly.

  1. C320495
    Detach the 3 claws and remove the spiral with sensor cable sub-assembly.

← REMOVAL (Jan 2015 – Mar 2016)REMOVAL (from Jan 2017) →