DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1.
REMOVE VACUUM PUMP PULLEY |
 |
- Using soft jaws, place vacuum pump in a vise, and remove the pulley lock nut and pulley.
| 2.
REMOVE VACUUM PUMP VACUUM HOSE UNION |
 |
- Using SST, hold the check valve assembly, and remove the union bolt, vacuum hose union and 2 gaskets.
- SST
- 09922-10010
| 3.
REMOVE BRAKE VACUUM CHECK VALVE ASSEMBLY |
 |
- Remove the check valve assembly and gasket.
| 4.
REMOVE VACUUM PUMP END COVER |
 |
- Remove the 4 screws and the end cover.
| 5.
REMOVE VACUUM PUMP SHAFT |
 |
- Using a plastic hammer, tap out the vacuum pump shaft with bearing.
| 6.
REMOVE STOP RING |
 |
Remove the stop ring from the vacuum pump shaft.
| 7.
REMOVE VACUUM PUMP BEARING |
 |
- Using a press, remove the bearing from the rotor shaft.
| 8.
REMOVE VACUUM PUMP BLADE A |
 |
- Remove the 2 screws and the end plate.
Remove the rotor and the 5 pump blades.
| 9.
REMOVE O-RING |
 |
Remove the O-ring from the casing.
| 10.
REMOVE OIL SEAL |
 |
- Using a screwdriver, remove the oil seal.