REASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1.
INSTALL VACUUM PUMP SHAFT |
 |
- Using a press, install the new ball bearing to the vacuum pump shaft.
- Using SST and a press, install the vacuum pump shaft to the housing.
- SST
- 09608-04031
- Using a snap ring pliers, install the snap ring.
| 2.
INSTALL VACUUM PUMP ROTOR ASSEMBLY |
 |
Apply the engine oil to the rotor, and install the rotor in the vacuum pump shaft.
| 3.
INSTALL VACUUM PUMP BLADE A |
 |
- Apply the engine oil to the 5 vacuum pump blades.
Install the 5 vacuum pump blades into the vacuum pump housing.
- NOTICE:
- Install the vacuum pump blades A with round end facing the inner surface of the vacuum pump housing.
- Install the vacuum pump blades A with round end touching the inner surface of the vacuum pump housing
- When reusing the vacuum pump blades A, be sure to reinstall each blade to its original slit on the rotor.
- Be sure to install the vacuum pump blades A in the correct direction as shown in the illustration.
| 4.
INSTALL VACUUM PUMP END COVER |
 |
- Place the vacuum pump in a vise, as shown in the illustration.
- NOTICE:
- Do not tighten the vise excessively.
Apply the engine oil to the 2 O-rings.
Install the 2 new O-rings and the vacuum pump end cover temporarily with the 3 bolts.
Using a pin punch (φ5 mm) and hammer, drive in the 2 straight pins.
- Fully tighten the 3 bolts.
-
Torque:
- 7.8 N*m{
80 kgf*cm
, 69 in.*lbf
}
| 5.
INSTALL CHECK VALVE ASSEMBLY |
 |
Install a new gasket and the check valve.
-
Torque:
- 74 N*m{
750 kgf*cm
, 54 ft.*lbf
}
| 6.
INSTALL VACUUM PUMP GEAR |
 |
Temporarily install the woodruff key, vacuum pump gear and gear lock nut to the pump shaft.
Using soft jaws, clamp the vacuum pump gear in the vise.
- NOTICE:
- Do not tighten the vise excessively.
Tighten the gear lock nut.
-
Torque:
- 110 N*m{
1125 kgf*cm
, 81 ft.*lbf
}
| 7.
INSPECT VACUUM PUMP ASSEMBLY |
 |
- Turn the gear in the vacuum pump counter-clockwise (left-hand turn, viewed from the gear side) and check for improper movement or torque change.