2014-2019 Hiace · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL DISC BRAKE CYLINDER ASSEMBLY

  1. C102587E01
    Install the disc brake cylinder assembly with the 2 bolts.

    Torque:
    34 N*m{ 350 kgf*cm , 25 ft.*lbf }


2. CONNECT FRONT FLEXIBLE HOSE

  1. C102586
    Connect the flexible hose with the union bolt and a new gasket.

    Torque:
    30 N*m{ 310 kgf*cm , 22 ft.*lbf }

    NOTICE:
    Make sure that the stopper of the flexible hose No.1 is securely holding on the cylinder assembly.


3. ADD BRAKE FLUID

Fluid:
SAE J1703 or FMVSS No. 116 DOT3 or equivalent


4. BLEED BRAKE LINE
  1. Connect the vinyl tube to the bleeder plug.

  1. Depress the brake pedal several times and loosen the bleeder plug with the pedal held down.

  1. At the point where the fluid stops coming out, tighten the bleeder plug and release the brake pedal.

  1. Repeat this procedure until the air in the brake fluid is completely bled out.

  1. Tighten the bleeder plug.

    1. Front bleeder plug:

      Torque:
      10.8 N*m{ 110 kgf*cm , 8 ft.*lbf }

    2. Rear bleeder plug:

      Torque:
      11.0 N*m{ 112 kgf*cm , 8 ft.*lbf }

  1. Repeat the above procedure to bleed the air out of the brake line for each wheel.


5. INSPECT BRAKE FLUID LEVEL
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1703 or FMVSS No.116 DOT3 or equivalent


6. CHECK BRAKE FLUID LEAKAGE

7. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }

← REASSEMBLY (from Oct 2014)COMPONENTS (from Oct 2014) →