2014-2019 Hiace · Service Manual BRAKE

REASSEMBLY

Removal / installation · Vehicles built from Jan 2015


1. INSTALL BRAKE ACTUATOR BOLT CUSHION
  1. Install the 3 brake actuator bolt cushions to the No. 1 brake actuator bracket.


2. INSTALL BRAKE ACTUATOR CASE COLLAR
  1. Install the 3 brake actuator case collars to the brake actuator bolt cushion.


3. INSTALL NO. 1 BRAKE ACTUATOR BRACKET
  1. Install the No. 1 brake actuator bracket to the brake actuator assembly with the 3 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    NOTICE:
    1. Do not remove the hole plug until the new brake actuator assembly is connected because it already contains brake fluid.
    2. Insert the protrusion of the brake actuator case collar between the positioning claws of the No. 1 brake actuator bracket.
    3. Insert the positioning pin of the No. 1 brake actuator bracket into the brake actuator bolt cushion of the brake actuator assembly.

← DISASSEMBLY (from Jan 2015)INSTALLATION (from Jan 2015) →