2014-2019 Hiace · Service Manual SUSPENSION & AXLE

INSTALLATION

Removal / installation · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017


1. TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM

  1. C102013E02
    Temporarily install the suspension lower arm and washer to the vehicle with the nut.

  1. Align the matchmarks on the front suspension No.1 camber adjust cam, front suspension No.2 camber adjust cam and suspension member.

  1. Temporarily tighten the washer and nut.

    NOTICE:
    Align the matchmarks.

  1. C102012E01
    Install front suspension lower arm to the front lower ball joint with the 2 bolts and 2 nuts.

    Torque:
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }


2. INSTALL FRONT STRUT BAR

  1. C102048E01
    Install the tube, strut bar cushion, strut bar retainer and washer to the strut bar and temporarily tighten the nut.

    NOTICE:
    Do not place the strut bar retainer and strut bar cushion in the wrong directions.

  1. C102011E01
    Install the strut bar to the front suspension lower arm with the 2 bolts and 2 nuts.

    Torque:
    90 N*m{ 918 kgf*cm , 66 ft.*lbf }


3. CONNECT FRONT SHOCK ABSORBER

  1. C102009E02
    Connect the front shock absorber to the front suspension lower arm with the bolt.

    Torque:
    105 N*m{ 1,070 kgf*cm , 77 ft.*lbf }


4. CONNECT FRONT STABILIZER LINK ASSEMBLY
  1. Install the 2 retainers and cushion.

  1. Connect the stabilizer bar link to the front suspension lower arm.

  1. Install the cushion and retainer to the front suspension lower arm.

  1. C113869E01
    Install and tighten a new lock nut until the protrusion length of the thread is the standard length.

    Standard:
    5 +- 1 mm (0.20 +- 0.04 in.)


5. INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }


6. STABILIZE SUSPENSION

7. FULLY TIGHTEN FRONT LOWER SUSPENSION ARM

  1. C102013E02
    Align the matchmarks on front suspension No.1 camber adjust cam and front suspension No.2 camber adjust cam and fully tighten the nut.

    Torque:
    170 N*m{ 1,730 kgf*cm , 125 ft.*lbf }


8. FULLY TIGHTEN FRONT STRUT BAR

  1. C102010E02
    Fully tighten the strut bar nut (rear side).

    Torque:
    138 N*m{ 1,410 kgf*cm , 102 ft.*lbf }


9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
(Click here)
← REASSEMBLY (from Oct 2014)INSTALLATION (Jan 2015 – Nov 2015) →