2014-2019 Hiace · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE FRONT WHEEL

2. SEPARATE FRONT SPEED SENSOR

  1. C112932E01
    Remove the 2 bolts and 2 clips to separate the front speed sensor.


3. SEPARATE FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY

  1. C102283E01
    Remove the 2 bolts, and disconnect the brake caliper assembly.

    NOTICE:
    Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.


4. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and the nut.

  1. C101339E01
    Using SST, separate the tie rod end sub-assembly LH from the steering knuckle.
    SST
    09628-00011  

    NOTICE:
    1. Hang SST with a string, or other means, to prevent it from falling.
    2. Do not damage the front disc brake dust cover.
    3. Do not damage the ball joint dust cover.
    4. Do not damage the steering knuckle.


5. REMOVE FRONT AXLE ASSEMBLY

  1. C102287
    Remove the 4 bolts, 4 nuts and front axle assembly from the front suspension lower arm.

  1. Remove the cotter pin and castle nut.

  1. C102660E01
    Using SST, remove the front axle assembly from the front suspension upper arm.
    SST
    09628-62011  

    NOTICE:
    1. Do not damage the ball joint dust boot.
    2. Apply grease to the threads and tip of the SST center bolt before use.
    3. Make sure that the string of the SST is securely tied to the vehicle.


6. REMOVE FRONT LOWER BALL JOINT
  1. Fix the steering knuckle in the vise using aluminum plates.

    NOTICE:
    Do not damage the steering knuckle.

  1. Remove the cotter pin.

  1. Loosen the nut.

  1. C194033E01
    Using SST, separate the front lower ball joint from the steering knuckle.
    SST
    09628-00011  

    NOTICE:
    1. Do not damage the ball joint dust boot.
    2. Make sure that the string of the SST is securely tied to the steering knuckle.

  1. Remove the nut and front lower ball joint.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →