2014-2019 Hiace · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Oct 2014 – Dec 2016

Versions by build date: Oct 2014 – Dec 2016 from Jan 2017

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

  1. B102872E01
    Detach the 3 clips and remove the front door lower frame bracket garnish LH.

  1. Remove the 3 remaining clips on the body, and reinstall them to the front door lower frame bracket garnish LH.


2. REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window, w/ Retract Mirror)

  1. B280660E02
    Insert a clip remover between the front door regulator inside handle plate and front door trim board sub-assembly LH.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the clip remover tip before use.

  1. Turn the handle clockwise to remove the snap ring, front door window regulator handle assembly and plate assembly.


3. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (w/ Power Window, w/ Retract Mirror)

  1. B366932
    Remove the 2 screws.

  1. Using a moulding remover, detach the 3 clips and 4 claws.

  1. Disconnect the switch connector and remove the power window regulator master switch assembly.


4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (w/o Power Window, W/ Retract Mirror)

  1. B102848E01
    Remove the 3 screws.

  1. Using a clip remover, detach the 12 clips and remove the front door trim board sub-assembly LH.

    NOTICE:
    1. Do not place hands on the pocket when removing the front door trim board sub-assembly.
    2. The pocket may detach and discoloration or damage may occur if hands are placed on the pocket when removing the front door trim board sub-assembly.

    HINT:
    If a clip cannot be reached with the clip remover, pull on the lower trim to remove it.


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH (w/ Power Window, w/ Retract Mirror)

  1. B102849E01
    Remove the screw.

  1. Using a clip remover, detach the 12 clips and remove the front door trim board sub-assembly LH.

    NOTICE:
    1. Do not place hands on the pocket when removing the front door trim board sub-assembly.
    2. The pocket may detach and discoloration or damage may occur if hands are placed on the pocket when removing the front door trim board sub-assembly.

    HINT:
    If a clip cannot be reached with the clip remover, pull on the lower trim to remove it.


6. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

  1. B112363
    w/o Retract Mirror:

    1. Remove the 3 nuts and outer rear view mirror assembly LH.

  1. B367094
    w/ Retract Mirror:

    1. Disconnect the connector.

    2. Detach the clamp and remove the 3 nuts and outer rear view mirror assembly LH.

← COMPONENTS (from Oct 2014)REMOVAL (from Jan 2017) →