2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2016 from Jan 2017


1. INSTALL FRONT NO.1 SPEAKER ASSEMBLY

  1. E106943E01
    Using an air riveter or hand riveter, install 3 new strike rivets on the front No.1 speaker assembly on the front door panel.

    HINT:
    Install the new strike rivets in order as shown in the illustration.

    NOTICE:

    1. H002440
      Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.

    2. H002441
      Confirm that the rivets are seated properly against the speaker.
    3. Do not tilt the riveter when installing the rivet to the speaker.
    4. Do not leave any space between the rivet head and speaker.

    5. H002442
      Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.

  1. Connect the connector.


2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

  1. B102849E01
    Attach the 12 clips and install the front door trim board sub-assembly LH with the screw.


3. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (Without Power Window)
  1. Temporarily install the front door window regulator handle assembly, and completely close the front door glass.

  1. B102871E01
    Install the front door window regulator handle assembly with front door window regulator handle shaft snap ring at the angle shown in the illustration.

← INSTALLATION (Oct 2014 – Dec 2016)COMPONENTS (from Oct 2014) →