2014-2019 Hiace · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH

  1. B103256
    Remove the bolt and disconnect the front seat outer belt assembly LH.

  1. B103245E02
    Using a screwdriver, detach the 2 claws and open the cover.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape

  1. B103246
    Remove the bolt and disconnect the front seat outer belt assembly LH.


2. REMOVE BACK DOOR SCUFF PLATE

  1. B106176E01
    Detach the 7 clips and 4 claws and remove the back door scuff plate.


3. REMOVE BACK DOOR WEATHERSTRIP

4. REMOVE QUARTER TRIM PANEL ASSEMBLY REAR LH

  1. B113348
    Detach the 35 clips and remove the quarter trim panel assembly rear LH.


5. REMOVE QUARTER PILLAR GARNISH LH

  1. B106184E02
    Detach the 6 clips and remove the quarter pillar garnish LH.


6. REMOVE ROOF SIDE GARNISH INNER UPPER LH

  1. B113352
    Using a screwdriver, detach the 6 clips and remove the roof side garnish inner upper LH.

    HINT:
    Tape the screwdriver tip before use.


7. REMOVE EMERGENCY HAMMER CAUTION PLATE (w/ Emergency Hammer Caution Plate)

HINT:
  1. If a emergency hammer caution plate is damaged, replace it with a new one.
  2. Only for the RH side.

  1. Remove the emergency hammer caution plate.


8. REMOVE REAR QUARTER WINDOW GLASS

  1. Apply protective tape to the outer surface of the vehicle body to prevent scratches.

    B397568E01

    Text in Illustration 
    *A
    w/o Window Seal Set Plate
    *B
    w/ Window Seal Set Plate

  1. From the interior, insert piano wires between the vehicle body and rear quarter window glass as shown in the illustration.

  1. Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

    NOTICE:
    When separating the rear quarter window glass from the vehicle, be careful not to damage the vehicles paint or interior/exterior ornaments.

  1. Cut through the adhesive by pulling the piano wire around the rear quarter window glass.

  1. Using a suction cup, remove the rear quarter window glass.

    NOTICE:
    Leave as much adhesive on the vehicle body as possible when removing the rear quarter window glass.


9. REMOVE NO. 1 REAR SIDE WINDOW ADHESIVE DAM LH
  1. Using a scraper, remove the No. 1 rear side window adhesive dam LH.

    NOTICE:
    1. Be careful not to damage the No. 1 rear side window adhesive dam LH.
    2. Be sure to replace the No. 1 rear side window adhesive dam LH with a new one.


10. REMOVE REAR SIDE WINDOW SEAL SET PLATE LH (w/ Window Seal Set Plate)

  1. B397558
    Using a scraper, remove the rear side window seal set plate LH.

    NOTICE:
    1. Be careful not to damage the rear side window assembly LH.
    2. Be sure to replace the rear side window seal set plate LH with a new one.

← REMOVAL (Oct 2014 – Mar 2016)REMOVAL (from Jan 2017) →