INSTALLATION
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2016 from Jan 2017
| 1. INSTALL LICENSE PLATE LIGHT ASSEMBLY |
Install the 2 license plate lights to the back door outside garnish.
Attach the 2 wire harness clamps and install the 2 screws.
| 2. INSTALL BACK DOOR OUTSIDE GARNISH |
Install the grommet.

Attach the 2 clips to install the back door outside garnish.
Install the 5 nuts.
w/ Smart Entry and Start System:
Connect the 2 connectors.
w/o Smart Entry and Start System:
Connect the connector.
| 3. INSTALL BACK DOOR TRIM BOARD (for Molded Door Trim) |
Attach the 18 clips to install the back door trim board.

Install the 2 screws.
| 4. INSTALL BACK DOOR TRIM BOARD (for Board) |
Install the back door trim board with the 16 clips.

| 5. INSTALL BACK DOOR INSIDE HANDLE BEZEL (w/ Back Door Inside Handle Bezel) |
![]() ![]() |
w/o Illumination:
Install the back door inside handle bezel with the 2 screws.
w/ Illumination:
Connect the connector.
Install the back door inside handle bezel with the 2 screws.
Text in Illustration *A
w/o Illumination:
*B
w/ Illumination:
| 6. INSTALL BACK DOOR INSIDE HANDLE (w/ Back Door Inside Handle) |
Install the back door inside handle assembly with the screw.

| 7. INSPECT LICENSE PLATE LIGHT ASSEMBLY |
Turn the ignition switch to on.
Turn the headlight dimmer switch to the tail or head position and check that the license plate light illuminates.

