2014-2019 Hiace · Service Manual ENGINE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built Jan 2015 – Nov 2015

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

NOTICE:
When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data stored in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.

HINT:
  1. DTCs which are stored in the ECM can be output to the intelligent tester. The intelligent tester can display the current and pending DTCs.
  2. Some DTCs are not stored if the ECM does not detect the same malfunction again during a second consecutive driving cycle. However, such malfunctions, detected on only one occasion, are stored as pending DTCs.


CHECK DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Powertrain / Engine and ECT / DTC.

  5. Check the DTCs and freeze frame data, and then write them down.

  6. Check the details of the DTCs (Click here).


CLEAR DTC
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Powertrain / Engine and ECT / DTC.

  5. Clear the DTCs.


CLEAR DTC (Without using the intelligent tester)
  1. Perform either of the following operations:

    1. Disconnect the cable from the negative (-) battery terminal for more than 1 minute.

    2. Remove the EFI NO.2 and ETCS fuses from the No. 1 engine room relay block for 1 minute or more.

← DTC CHECK / CLEAR (Oct 2014 – Dec 2014)DTC CHECK / CLEAR (Dec 2015 – Mar 2016) →