2014-2019 Hiace · Service Manual ENGINE

BASIC INSPECTION

Troubleshooting · Vehicles built from Oct 2014

When a malfunction is not confirmed by the DTC (Diagnostic Trouble Code) check, troubleshooting should be carried out in all circuits considered to be possible causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location of the problem can be found quickly and efficiently. Therefore, using this check is essential when troubleshooting the engine.

1.CHECK BATTERY VOLTAGE

    NOTICE:
    Carry out this check with the engine stopped and ignition switch off.

    Standard voltage:
    OK
    NG
    11 V or more
    Less than 11 V


NG.
OK

2.CHECK IF ENGINE WILL CRANK

    NG.
    OK

    3.CHECK AIR FILTER
    1. Visually check that the air filter is not excessively contaminated with dirt or oil.


    NG.
    OK

    4.CHECK FUEL QUALITY
    1. Check that only diesel fuel has been used.

    2. Check that the fuel does not contain any impurities.


    NG .
    OK

    5.CHECK FUEL FOR AIR

      NG.
      OK

      6.CHECK FUEL PIPES AND HOSES
      1. Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected and bent.


      NG.
      OK

      7.CHECK FUEL FILTER FOR BLOCKAGE

        NG.
        OK

        8.CHECK ENGINE OIL

          NG.
          OK

          9.CHECK ENGINE COOLANT

            NG.
            OK

            10.CHECK IDLING SPEED AND MAXIMUM SPEED

              NG.
              OK

              11.CHECK DIAGNOSTIC CIRCUIT

                NG.
                OK

                12.CHECK VACUUM PUMP

                  NG.
                  OK

                  ← CHECK FOR INTERMITTENT PROBLEMS (from Jan 2015)REGISTRATION (from Jan 2015) →