2014-2019 Hiace · Service Manual ENGINE

P0604 Internal Control Module Random Access Memory (RAM) Error

Diagnostic trouble codes · Vehicles built from Oct 2014

Also covers:

MONITOR DESCRIPTION

The ECM continuously monitors its own internal memory status, internal circuits, and output signals transmitted to the throttle actuator. This self-check insures that the ECM is functioning properly. If any malfunction is detected, the ECM sets the appropriate DTC and illuminates the MIL.
The ECM memory status is diagnosed by internal mirroring of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The two CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the two CPUs are different or deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.
DTC No.
DTC Detection Conditions
Trouble Areas
P0604
P0606
P0607
P060A
P060D
P060E
P0657
ECM internal error (1 trip detection logic)
  1. ECM

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK WHETHER DTC OUTPUT RECURS
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    DTC P0604, P0606, P0607, P060A, P060D, P060E and/or P0657 is output
    A
    DTC is not output
    B



B
CHECK FOR INTERMITTENT PROBLEMS
A

REPLACE ECM


← P0560 System Voltage (from Dec 2017)P0617 Starter Relay Circuit High (Oct 2014 – Dec 2014) →