2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT PRESSURE SENSOR
  1. Install the manifold gauge set.

  1. Start the engine.

  1. Operate the air conditioning system.

  1. Disconnect the pressure sensor connector.

  1. Connect the positive (+) lead from three 1.5 V dry cell batteries to terminal 3 and negative (-) lead to terminal 1.

  1. E113142E01
    Check the voltage between terminals 2 and 1 of the pressure sensor.

    Standard voltage:
    The voltage varies with the refrigerant pressure as shown in the chart.

    If the voltage value is not as specified, replace the pressure sensor.

← ON-VEHICLE INSPECTION (from Oct 2014)ON-VEHICLE INSPECTION (from Oct 2014) →