2014-2019 Hiace · Service Manual TRANSMISSION

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built Dec 2015 – Mar 2016

Versions by build date: Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 Jan 2017 – Nov 2017 from Dec 2017

HINT:
  1. The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN and multiplex communication system.
  2. *: Use the GTS.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section (Click here).

    NEXT

    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    4.CONNECT GTS TO DLC3*
      NEXT

      5.CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*
      1. Refer to DTC Check/Clear (Click here).

      NEXT

      6.VISUAL INSPECTION
        NEXT

        7.SELECT CHECK MODE DIAGNOSIS*
        1. Refer to Check Mode Procedure (Click here).

        NEXT

        8.PROBLEM SYMPTOM CONFIRMATION
        1. Refer to Road Test (Click here).

          Result 
          Result
          Proceed to
          Symptom does not occur
          A
          Symptom occurs
          B


        B.
        A

        9.SYMPTOM SIMULATION
        1. Refer to Symptom Simulation (Click here).

        NEXT

        10.DTC CHECK*
        1. Refer to DTC Check/Clear (Click here).

          Result 
          Result
          Proceed to
          DTC is not output
          A
          DTC is output
          B


        B.
        A

        11.BASIC INSPECTION
        1. Refer to Park/Neutral Position Switch Assembly (Click here).

        2. Refer to Shift Lever Assembly (Click here).


        NG.
        OK

        12.MECHANICAL SYSTEM TESTS
        1. Refer to Mechanical System Tests (Click here).


        NG.
        OK

        13.HYDRAULIC TEST
        1. Refer to Hydraulic Test (Click here).


        NG.
        OK

        14.MANUAL SHIFTING TEST
        1. Refer to Manual Shifting Test (Click here).


        NG.
        OK

        15.PROBLEM SYMPTOMS TABLE CHAPTER 1
        1. Refer to Problem Symptoms Table (Click here).


        NG.
        OK

        16.PROBLEM SYMPTOMS TABLE CHAPTER 2
        1. Refer to Problem Symptoms Table (Click here).

        NEXT

        17.COMPONENT INSPECTION

          NEXT.
          18.DTC CHART
          1. Refer to Diagnostic Trouble Code Chart (Click here).

          NEXT

          19.CIRCUIT INSPECTION
            NEXT

            20.IDENTIFICATION OF PROBLEM
              NEXT

              21.REPAIR OR REPLACE
                NEXT

                22.CONFIRMATION TEST
                  NEXT

                  ← HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2015 – Nov 2015)HOW TO PROCEED WITH TROUBLESHOOTING (Apr 2016 – Dec 2016) →