2014-2019 Hiace · Service Manual TRANSMISSION

HYDRAULIC TEST

Troubleshooting · Vehicles built from Jan 2015


PERFORM HYDRAULIC TEST

  1. Measure the line pressure.

    CAUTION:
    The line pressure test should always be performed with at least 2 people. One person should observe the condition of the wheels and wheel chocks while the other is performing the test.

    NOTICE:
    1. Perform the test while the ATF (Automatic Transmission Fluid) temperature is between 50 and 80°C (122 and 176°F).
    2. Be careful to prevent the hose of SST from interfering with the exhaust pipe.
    3. This check must be conducted after checking and adjusting the engine.
    4. Perform the test with the air conditioning off.
    5. When conducting stall test, do not continue for more than 5 seconds.


    1. Warm up the ATF (Automatic Transmission Fluid).

    2. Turn the ignition switch off.

    3. Lift the vehicle up.

    4. C323247E01
      Remove the test plug from the transmission case and connect SST.
      SST
      09992-00095   (09992-00231, 09992-00271)

    5. Lower the vehicle.

    6. Fully apply the parking brake and chock the 4 wheels.

    7. Start the engine and check the idling speed.

    8. Keep your left foot pressed firmly on the brake pedal and move the shift lever to D.

    9. Fully depress the accelerator pedal with your right foot. Quickly read the highest line pressure when the engine speed reaches the stall speed.

    10. In the same manner, perform the test with the shift lever in R.

      Specified Line Pressure 
      Condition
      D Position
      R Position
      Stall speed
      1550 to 1840 kPa
      (15.8 to 18.8 kgf/cm2, 225 to 267 psi)
      1550 to 1840 kPa
      (15.8 to 18.8 kgf/cm2, 225 to 267 psi)
      Evaluation 
      Problem
      Possible Cause
      Measured values are higher than the specified value in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      Measured values are lower than the specified value in all positions
      1. Shift solenoid valve SLT defective
      2. Regulator valve defective
      3. Oil pump defective
      Pressure is low in D position only
      1. D position circuit fluid leak
      2. No. 1 clutch (C1) defective
      Pressure is low in R position only
      1. R position circuit fluid leak
      2. No. 2 brake (B2) defective
      3. No. 3 brake (B3) defective

← MECHANICAL SYSTEM TESTS (from Jan 2015)MANUAL SHIFTING TEST (Jan 2015 – Mar 2016) →