2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT VACUUM SWITCHING VALVE ASSEMBLY NO.1 (EVAP VSV)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    23 to 26 Ω
    1 - Body ground
    Always
    10 MΩ or higher
    2 - Body ground

    HINT:
    When measuring the coil resistance make sure that the surface temperature of the vacuum switching valve assembly No.1 is 20°C (68°F).

    If the result is not as specified, replace the vacuum switching valve assembly No.1.

  1. Check the operation.

    1. A160987E07
      Check that air does not flow from port E to port F.

    2. Apply battery voltage across the terminals.

    3. A160988E06
      Check that air flows from port E to port F.
      If the result is not as specified, replace the vacuum switching valve assembly No.1.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →