ON-VEHICLE INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 |
Belt deflection:

- Pressing force:
- 98 N (10 kgf)
New belt mm (in.)
Used belt mm (in.)
Belt deflection
11 to 15
(0.43 to 0.59)
15 to 20
(0.59 to 0.78)
Belt tension:

Using a belt tension gauge, check the V belt tension.Measuring point
New belt
N (kgf)
Used belt
N (kgf)
Belt tension
372 to 608
(38 to 62)
196 to 392
(20 to 40)
- NOTICE:
- Check the V belt at the specified point.
- When installing a new belt, adjust the belt tension within the specified range.
- When readjusting the belt tension, adjust the belt once again after 5 minutes of idling so that tension is within the specified range.
- When installing a new belt, readjust the belt tension after 5 minutes of idling so that tension is within the specified range.
- Check that there is clearance between the V belt and pulley.
- Check the V belt at the specified point.
