2014-2019 Hiace · Service Manual BODY

REPAIR

Removal / installation · Vehicles built from Oct 2014


1. INSPECT WINDOW DEFOGGER WIRE

NOTICE:
When cleaning the glass, wipe it in the direction of the wire with a soft and dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring voltage, wind a piece of tin foil around the tip of the tester probe and press the foil against the wire with your finger, as shown in the illustration.

  1. E032576
    Check the continuity, as the center of each defogger wire, as shown in the illustration.


2. REPAIR WINDOW DEFOGGER WIRE

  1. BE00150E02
    Clean the broken wire tips with a grease, wax and silicone remover.

  1. Place the masking tape along both sides of the wire to be repaired.

  1. Thoroughly mix the repair agent (Dupont paste No.4817).

  1. BE00151E01
    Using a fine tip brush, apply a small amount of the mixture to the wire.

  1. After a few minutes, remove the masking the tape.

  1. Do not repair the defogger wire for at least 24 hours afterwards.

← TERMINALS OF ECU (from Oct 2014)PARTS LOCATION (from Oct 2014) →