2014-2019 Hiace · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL VANE PUMP ASSEMBLY
  1. Install a new vane pump O-ring to the vane pump assembly.

  1. C101372E01
    Install the vane pump assembly with the 2 nuts.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Make sure that the vane pump O-ring is not caught between other parts.


2. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install a new gasket to the pressure feed tube assembly.

  1. C101371E01
    Connect the pressure feed tube assembly to the vane pump assembly with the union bolt.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

    HINT:
    Make sure the stopper of the pressure feed tube assembly contacts the vane pump assembly as shown in the illustration.


3. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1

  1. C101370E01
    Connect the oil reservoir to pump hose No.1 to the vane pump assembly with the clip.


4. ADD POWER STEERING FLUID

5. BLEED POWER STEERING FLUID
(Click here)

6. CHECK FOR POWER STEERING FLUID LEAKS

7. INSTALL ENGINE UNDER COVER NO.2

8. INSTALL ENGINE UNDER COVER NO.1
← REASSEMBLY (from Oct 2014)COMPONENTS (from Jan 2017) →