2014-2019 Hiace · Service Manual STEERING

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. FIX VANE PUMP

  1. G020894E01
    Using SST, hold the vane pump assembly in a vice.
    SST
    09630-00014   (09631-00132)


2. REMOVE SUCTION PORT UNION
  1. Remove the bolt and the suction port union.

  1. Remove the O-ring from the suction port union.


3. REMOVE FLOW CONTROL VALVE

  1. C101967E01
    Remove the pressure port union.

  1. Remove the O-ring from the pressure port union.

  1. Remove the flow control valve and the compression spring.


4. REMOVE VANE PUMP REAR HOUSING

  1. G021499
    Remove the 4 bolts and the rear vane pump housing.

  1. Remove the O-ring from the rear vane pump housing.


5. REMOVE VANE PUMP ROTOR
  1. Remove the 10 vane pump plates.

  1. Remove the vane pump rotor.


6. REMOVE VANE PUMP CAM RING

7. REMOVE VANE PUMP FRONT SIDE PLATE
  1. Remove the front vane pump side plate from the front vane pump housing.

  1. C101969
    Remove the O-ring from the front vane pump side plate.

  1. C101970
    Remove the O-ring from the front vane pump housing.


8. REMOVE VANE PUMP GEAR

  1. C101971E01
    Using a screwdriver, remove snap ring from the front vane pump housing.

    HINT:
    Tape the screwdriver tip before use.

  1. Wrap the serration of the vane pump shaft with protective tape.

  1. C102430E01
    Using a press, remove the vane pump shaft from the front vane pump housing.

    NOTICE:
    Do not drop the vane pump shaft.

  1. Temporarily install the service bolt.

    Recommended service bolt:
    Thread diameter:
    10 mm (0.39 in.)
    Thread pitch:
    1.25 mm (0.0492 in.)
    Bolt length:
    50 mm (1.97 in.)

  1. C102431E01
    Using SST and a press, remove the vane pump gear from the vane pump shaft.
    SST
    09950-00020  


9. REMOVE VANE PUMP SHAFT BEARING

  1. C101974E01
    Using SST and a press, remove the vane pump shaft bearing from the vane pump shaft.
    SST
    09950-00020  

  1. C101975
    Using a snap ring expander, remove the vane pump shaft snap ring from the vane pump shaft.


10. REMOVE VANE PUMP HOUSING OIL SEAL

  1. C101976E01
    Using SST, remove the vane pump housing oil seal from the front vane pump housing.
    SST
    09319-60020  
    09527-10011  

← REMOVAL (from Oct 2014)INSPECTION (from Oct 2014) →