INSTALLATION
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL EXHAUST PIPE ASSEMBLY TAIL |
Connect the exhaust pipe support, and install the exhaust pipe assembly tail.
| 2. INSTALL EXHAUST PIPE ASSEMBLY CENTER |
Connect the exhaust pipe supports and install the exhaust pipe assembly center and a new gasket with the 2 bolts to the exhaust pipe assembly tail.
- Torque:
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
| 3. INSTALL EXHAUST PIPE ASSEMBLY FRONT |
Inspect the compression spring.
Using vernier calipers, measure the free length of the compression springs.

- Minimum length:
- 40.5mm(1.594 in.)
- HINT:
- If the free length is less than the minimum, replace the compression spring.
Install the gasket.

Fully insert a new gasket to the exhaust manifold by hand.
Using a wooden block, uniformly strike the gasket so that the gasket and exhaust manifold are properly fit.
- NOTICE:
- Be careful with the installation direction of the gasket.
- Do not reuse the gasket.
- Do not damage the gasket.
- To ensure a proper seal, do not use the exhaust pipe assembly front to force the gasket onto the front exhaust manifold.
- Be careful with the installation direction of the gasket.
Connect the exhaust pipe support, and install the exhaust pipe assembly front and a new gasket with the 4 bolts, 2 compression springs and 2nuts.
- Torque:
- Exhaust manifold side:
- 43 N*m{ 438 kgf*cm , 32 ft.*lbf }
- Exhaust pipe assembly center side:
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
- NOTICE:
- After installation, check that the clearance is almost same at any point between the flanges of the exhaust manifold and exhaust pipe assembly front .
| 4. CHECK FOR EXHAUST GAS LEAKS |
