2014-2019 Hiace · Service Manual BODY

Front Passenger Side Power Window Motor Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

This circuit transmits signals from the power window switch to the power window regulator motor (Front passenger side).

WIRING DIAGRAM

B111211E07

INSPECTION PROCEDURE


1. INSPECT POWER WINDOW REGULATOR MOTOR

  1. B059442E01
    Remove the power window motor.

  1. Apply battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply battery to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1 (D)
    Battery negative (-) → Terminal 2 (U)
    Motor gear rotates counterclockwise
    Battery positive (+) → Terminal 2 (U)
    Battery negative (-) → Terminal 1 (D)
    Motor gear rotates clockwise



NG
REPLACE POWER WINDOW REGULATOR MOTOR
OK


2. CHECK WIRE HARNESS (WINDOW REGULATOR MOTOR - POWER WINDOW SWITCH)

  1. B111215E05
    Disconnect the L6 (K6) and K4 (L4) connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LHD Models:
    Tester Connection
    Condition
    Specified Condition
    K6-3 (U) - K4-2 (U)
    Always
    Below 1 Ω
    K6-1 (D) - K4-1 (D)
    Always
    Below 1 Ω
    K6-3 (U) - Body ground
    Always
    10 kΩ or higher
    K6-1 (D) - Body ground
    Always
    10 kΩ or higher
    RHD Models:
    Tester Connection
    Condition
    Specified Condition
    L6-3 (U) - L4-2 (U)
    Always
    Below 1 Ω
    L6-1 (D) - L4-1 (D)
    Always
    Below 1 Ω
    L6-3 (U) - Body ground
    Always
    10 kΩ or higher
    L6-1 (D) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Driver Side Power Window Motor Circuit (from Oct 2014)INSPECTION (from Oct 2014) →