2014-2019 Hiace · Service Manual BRAKE

PRECAUTION

Precautions · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

NOTICE:
When disconnecting the battery terminal, initialize the following system after the terminal is reconnected.

System
See procedure
Power window control system
Click here

1.IGNITION SWITCH EXPRESSION

HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Expression
Ignition Switch (Position)
Engine Switch (Condition)
Ignition Switch off
LOCK
Off (Lock)
Ignition Switch ACC
ACC
On (ACC)
Ignition Switch ON
ON
On (IG)
Engine Start
START
On (Start)

2.TROUBLESHOOTING PRECAUTION

HINT:
The anti-lock brake system includes the ABS and BA (Click here).

NOTICE:
  1. When there is a malfunction in the terminal contact points or installation problems with parts, removing and installing the suspected problem parts may return the system to normal, either completely or temporarily.
  2. In order to determine the malfunctioning area, be sure to check the conditions at the time the malfunction occurred, such as by the DTC output and the freeze frame data output, and record it, before disconnecting each connector or removing and installing pats.
  3. Be sure to remove and install the brake actuator and each individual sensor with the ignition switch off unless specified otherwise in the inspection procedure.
  4. When removing and installing the brake actuator and each individual sensor, be sure to check that the normal display is output in Test Mode inspection and DTC output inspection after installing all the parts.

← INSTALLATION (from Jan 2017)PRECAUTION (Jan 2015 – Mar 2016) →