DATA LIST / ACTIVE TEST
System information · Vehicles built from Jan 2015
Versions by build date: Oct 2014 – Dec 2014 from Jan 2015
| DATA LIST |
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
- HINT:
- Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List.
According to the display on the GTS, read the Data List.
ABS/VSC/TRC Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
ABS Warning Light
ABS warning light / ON or OFF
ON: Warning light on
OFF: Warning light off
-
Stop Light SW
Stop light switch assembly / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Parking Brake SW
Parking brake switch assembly / ON or OFF
ON: Parking brake applied
OFF: Parking brake released
-
Inspection Mode
Inspection mode / Other or Inspect
Inspect: Inspection mode
Other: Normal mode
-
FR Wheel Speed
Front wheel speed sensor RH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations
FL Wheel Speed
Front wheel speed sensor LH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations
RR Wheel Speed
Rear wheel speed sensor RH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations
RL Wheel Speed
Rear wheel speed sensor LH reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations
Vehicle Speed
Maximum wheel speed sensor reading / Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations
FR Wheel Acceleration
Front wheel RH acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
-
During deceleration/acceleration: Changes continuously
FL Wheel Acceleration
Front wheel LH acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
-
During deceleration/acceleration: Changes continuously
RR Wheel Acceleration
Rear wheel RH acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
-
During deceleration/acceleration: Changes continuously
RL Wheel Acceleration
Rear wheel LH acceleration / Min.: -200.84 m/s2, Max.: 199.27 m/s2
-
During deceleration/acceleration: Changes continuously
FR Wheel ABS Ctrl Status
Front wheel RH ABS control status / ON or OFF
ON: During control
OFF: Not during control
-
FL Wheel ABS Ctrl Status
Front wheel LH ABS control status / ON or OFF
ON: During control
OFF: Not during control
-
RR Wheel ABS Ctrl Status
Rear wheel RH ABS control status / ON or OFF
ON: During control
OFF: Not during control
-
RL Wheel ABS Ctrl Status
Rear wheel LH ABS control status / ON or OFF
ON: During control
OFF: Not during control
-
Solenoid Relay
Solenoid relay / ON or OFF
ON: Solenoid relay on
OFF: Solenoid relay off
-
ECB Motor Relay
Motor relay / ON or OFF
ON: Motor relay on
OFF: Motor relay off
ECB: Electronically Controlled Brake
ABS Solenoid (SFRH)
ABS solenoid (SFRH) / ON or OFF
ON: Operating
OFF: Not operating
-
ABS Solenoid (SFRR)
ABS solenoid (SFRR) / ON or OFF
ON: Operating
OFF: Not operating
-
ABS Solenoid (SFLH)
ABS solenoid (SFLH) / ON or OFF
ON: Operating
OFF: Not operating
-
ABS Solenoid (SFLR)
ABS solenoid (SFLR) / ON or OFF
ON: Operating
OFF: Not operating
-
ABS Solenoid (SRRH)
ABS solenoid (SRRH) / ON or OFF
ON: Operating
OFF: Not operating
-
ABS Solenoid (SRRR)
ABS solenoid (SRRR) / ON or OFF
ON: Operating
OFF: Not operating
-
FR Speed Open
Front speed sensor RH open detection / Error or Normal
Normal
Error: Momentary interruption
FL Speed Open
Front speed sensor LH open detection / Error or Normal
Normal
Error: Momentary interruption
RR Speed Open
Rear speed sensor RH open detection / Error or Normal
Normal
Error: Momentary interruption
RL Speed Open
Rear speed sensor LH open detection / Error or Normal
Normal
Error: Momentary interruption
IG1 Voltage Value
IG1 voltage value / Min.: 0.00 V, Max.: 20.00 V
Ignition switch ON: 11 to 14 V
Changes in proportion to battery voltage
MT Voltage Value
Motor voltage value / Min.: 0.00 V, Max.: 20.00 V
-
Changes in proportion to battery voltage
Number of DTC
Number of DTCs recorded / Min.: 0, Max.: 255
0
-
IG Voltage Value Decreased
IG voltage value decrease detection / Error or Normal
Normal
Error: Momentary interruption
IG Voltage Value Increased
IG voltage value increase detection / Error or Normal
Normal
Error: Momentary interruption
FR Speed Sensor Voltage Open
Front speed sensor RH voltage open detection / Error or Normal
Normal
Error: Momentary interruption
FL Speed Sensor Voltage Open
Front speed sensor LH voltage open detection / Error or Normal
Normal
Error: Momentary interruption
RR Speed Sensor Voltage Open
Rear speed sensor RH voltage open detection / Error or Normal
Normal
Error: Momentary interruption
RL Speed Sensor Voltage Open
Rear speed sensor LH voltage open detection / Error or Normal
Normal
Error: Momentary interruption
| ACTIVE TEST |
- HINT:
- Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.
According to the display on the GTS, perform the Active Test.
ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
ABS Warning Light
ABS warning light
Warning light ON/OFF
Observe combination meter assembly
Vehicle condition: Vehicle stopped
Solenoid Relay
Solenoid relay
Relay ON/OFF
Vehicle condition: Vehicle stopped
Motor Relay
Motor relay
Relay ON/OFF
Operating sound of motor can be heard.
Vehicle condition: Vehicle stopped
ABS Solenoid (SRRR)
ABS solenoid (SRRR)
Solenoid ON/OFF
Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped
ABS Solenoid (SRRH)
ABS solenoid (SRRH)
Solenoid ON/OFF
Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped
ABS Solenoid (SFLR)
ABS solenoid (SFLR)
Solenoid ON/OFF
Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped
ABS Solenoid (SFLH)
ABS solenoid (SFLH)
Solenoid ON/OFF
Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped
ABS Solenoid (SFRR)
ABS solenoid (SFRR)
Solenoid ON/OFF
Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped
ABS Solenoid (SFRH)
ABS solenoid (SFRH)
Solenoid ON/OFF
Operating sound of solenoid (clicking sound) can be heard.
Vehicle condition: Vehicle stopped
ABS Solenoid
Selection of multiple holding solenoids (SFRH, SFLH and SRRH) and pressure reduction solenoids (SFRR, SFLR and SRRR) possible
Start/Stop
Vehicle condition: Vehicle stopped