DESCRIPTION
The ECM monitors the battery. When the engine is running (not cranking) and the battery voltage drops below a specified level, the ECU determines that there is battery deterioration and stores this DTC.
DTC Code
|
DTC Detection Condition
|
Trouble Area
|
P1602
|
- Diagnosis condition: Engine running (except when cranking)
- Malfunction status: Battery capacity is abnormally low for 10 seconds or more
- Trip count: 1 trip detection logic
|
- Battery
- Harness or connector
|
MONITOR STRATEGY
Frequency of operation
|
Continuous
|
CONFIRMATION DRIVING PATTERN
- Connect the GTS to the DLC3.
- Turn the ignition switch to ON and turn the GTS on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC operation).
- Turn the ignition switch off and wait for at least 30 seconds.
- Turn the ignition switch to ON and turn the GTS on.
- Start the engine with all the accessories switched off.
- Wait for 10 seconds or more.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
- Read Pending DTCs.
- HINT:
- If a pending DTC is output, the system is malfunctioning.
- If a pending DTC is not output, perform the following procedure.
- Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
- Input the DTC: P1602.
- Check the DTC judgment result.
GTS Display
|
Description
|
NORMAL
|
- DTC judgment completed
- System normal
|
ABNORMAL
|
- DTC judgment completed
- System abnormal
|
INCOMPLETE
|
- DTC judgment not completed
- Perform driving pattern after confirming DTC enabling conditions
|
N/A
|
- Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit
|
- HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows INCOMPLETE or N/A, perform the Confirmation Driving Pattern and check the DTC judgment result again.
WIRING DIAGRAM
Refer to DTC P0560 (Click here).INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK FOR ANY OTHER DTCS OUTPUT |
 |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
- Result:
Result
|
Proceed to
|
Only DTC P1602 is output.
|
A
|
Other DTCs are output in addition to DTC P1602.
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
| 2. CHECK CHARGING SYSTEM |
 |
Check the charging system (Click here).
|
NG |
 |
|
| REPAIR OR REPLACE CHARGING SYSTEM |
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
 |
- Disconnect the ECM connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Condition
|
Specified Condition
|
B94-1 (BATT) - Body ground
|
Always
|
9.5 to 16 V
|
Text in Illustration
*a
|
Front view of wire harness connector (to ECM)
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT) |
|
|
| OK |
|
 |
|
|