FREEZE FRAME DATA
Troubleshooting · Vehicles built from Jan 2017
| FREEZE FRAME DATA |
The ECM stores the vehicle condition when a DTC is output, and this information can be displayed using the GTS.
Freeze frame data when a DTC is output.
When a DTC is output, the freeze frame data at the time the DTC is output is stored.
When freeze frame data is stored when a DTC is output, the data is not updated or deleted until DTCs are cleared.
| CHECK FREEZE FRAME DATA |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Select a DTC to display the freeze frame data.
Check the freeze frame data for the output DTC.
| LIST OF FREEZE FRAME DATA |
- HINT:
- The chart below indicates the items related to the charging system from the freeze frame data recorded by the SFI system.
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Battery Voltage
Battery voltage/0.000 to 66.000 V
11 to 14 V
-
Alternator Output Duty
LIN1 terminal output (charge control signal)/0.0 to 399.9%
Changes in response to generator power generation amount during charging control
-
Alt Vol - Non Active Test
Request voltage when regulator not under forced activation/0.000 to 79.998 V
-
-
Alt Vol - Active Test
Request voltage when regulator under forced activation/0.000 to 79.998 V
-
-