DATA LIST / ACTIVE TEST
System information · Vehicles built from Jan 2017
| READ DATA LIST |
- HINT:
- Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
- NOTICE:
- In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
Check the values by referring to the table below.
Charging ControlĀ Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Battery Voltage
Battery voltage/0.000 to 66.000 V
11 to 14 V
When the value is outside of the specified range, there may be a problem with the battery
Alternator Output Duty
LIN1 terminal output (charge control signal)/0.0 to 399.9%
Changes in response to generator power generation amount during charging control
If the value does not change as specified, there may be a malfunction in the charging control system
Alt Vol - Non Active Test
Request voltage when regulator not under forced activation/0.000 to 79.998 V
-
Malfunction of the charging control system can be the cause of malfunction
Alt Vol - Active Test
Request voltage when regulator under forced activation/0.000 to 79.998 V
-
Malfunction of the charging control system can be the cause of malfunction
Previous Trip Alternator Max Output Time
Generator maximum generating time during previous drive/0 to 65535 sec.
-
-
Initial Engine Battery Minimum Voltage
Minimum battery voltage at engine start/0.0 to 26.0 V
-
-
| PERFORM ACTIVE TEST |
- HINT:
- Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
Perform the Active Test according to the display on the GTS.
| Tester Display |
Test Part |
Control Range |
Diagnostic Note |
| Control the Voltage of Alternator |
Forced generator power generation voltage command |
12.5 to 14.6 V |
This Active Test requires the engine to be running |