2014-2019 Hiace · Service Manual SUSPENSION & AXLE

TERMINALS OF ECU

System information · Vehicles built from Jan 2017


CHECK TIRE PRESSURE WARNING ECU AND RECEIVER

  1. Disconnect the T38 tire pressure warning ECU and receiver connector and measure the voltage or resistance on the wire harness side.
    C279757E13

    Text in Illustration  
    *a
    Front view of wire harness connector
    (to Tire Pressure Warning ECU and Receiver)
    -
    -
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T38-1 (IG) - T38-12 (GND)
    W - W-B
    IG power source
    Ignition switch ON
    10 to 16 V
    T38-12 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

  2. Connect the T38 tire pressure warning ECU and receiver connector.

  3. Measure the voltage according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

    HINT:
    Inspect the connectors from the back side while the connectors are connected.

    C371208E01
    Text in Illustration  
    *a
    Component with harness connected
    (Tire Pressure Warning ECU and Receiver)
    -
    -
    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    T38-7 (CLSW) - T38-12 (GND)
    GR - W-B
    Tire pressure warning reset switch
    1. Ignition switch ON
    2. Tire pressure warning reset switch on
    Below 1.5 V
    1. Ignition switch ON
    2. Tire pressure warning reset switch off
    8 to 15 V

← PROBLEM SYMPTOMS TABLE (from Dec 2017)DIAGNOSIS SYSTEM (Jan 2017 – Nov 2017) →