INITIALIZATION
Troubleshooting · Vehicles built Jan 2017 – Nov 2017
Versions by build date: Jan 2017 – Nov 2017 from Dec 2017
- NOTICE:
- Initialization can be confirmed through the tire pressure warning light.
- The order in which the data is received is random.
- If the signals from all the wheels are received, initialization is completed.
- Initialization is completed when the Data List "ID Tire Inflation Pressure" display shows the correct pressures (Click here).
- Initialization is normally completed within a few minutes.
- It may take up to a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25 (Click here).
- If initialization has not been completed successfully, DTC C2177/77 is stored after a vehicle speed of 40 km/h (25 mph) or more continues for 20 minutes or more.
- During test mode (sensor check mode), the system will not change to initialization mode even if the tire pressure warning reset switch is pushed.
- While the answer-back function for the ID switching function is operating, the system will not change to initialization mode even if the initialization procedure is performed.
-
Initialization can be terminated by connecting terminals 13 (TC) and 4 (CG) of the DLC3.

- Initialization can be confirmed through the tire pressure warning light.
| *a |
Front view of DLC3 |
| BEFORE INITIALIZATION |
Set the tire pressure to the specified value.
- HINT:
- Refer to the link as the procedure for adjusting the tire pressures differs depending on the temperature of the tires (Click here).
| INITIALIZATION PROCEDURE |
- HINT:
- The tire pressure warning system illuminates the tire pressure warning light to warn the driver when any of the following conditions are met:
- Due to the operation of the tire pressure warning reset switch, the tire pressure drops to approximately 75% or less of the tire pressure set during system initialization.
- The tire pressure drastically decreases (approximately 20 kPa (0.2 kgf/cm2, 2.9 psi) or more within several minutes) to approximately 75% or less of the tire pressure* when the tires are warmed.
*: If initialization is performed and the vehicle is driven for a certain period of time, the tire pressure set during system initialization is adjusted and set to the tire pressure when the tires are warmed from the driving conditions.- NOTICE:
- If the tire pressure is decreased approximately 20 kPa (0.2 kgf/cm2, 2.9 psi) or more in order to adjust the tire pressure, even if the adjusted tire pressure is 75% or more than the tire pressure set during system initialization, the tire pressure warning light may illuminate if the tire pressure drops below 75% of the tire pressure set when the tires are warmed. In this case, perform initialization again.
- Due to the operation of the tire pressure warning reset switch, the tire pressure drops to approximately 75% or less of the tire pressure set during system initialization.
Turn the ignition switch to ON.
Press and hold the tire pressure warning reset switch for 3 seconds or more so that the tire pressure warning light blinks 3 times.

Text in Illustration *1
Tire Pressure Warning Light
*2
Tire Pressure Warning Reset Switch
*a
Tire Pressure Warning Light Output Pattern
*b
1 sec.
*c
ON
*d
OFF
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Check that initialization has been completed.
Confirm that the tire pressure data of all tires is displayed on the GTS screen.