ON-VEHICLE INSPECTION
Inspection · Vehicles built Oct 2014 – Dec 2014
Versions by build date: Oct 2014 – Dec 2014 from Jan 2015
| INSPECT ENGINE OIL LEVEL |
Warm up the engine, stop the engine and wait 5 minutes.
Check that the oil level is between the dipstick low level mark and full level mark.
If the level is low, check for leakage and add oil up to the full level mark.- NOTICE:
- Do not fill with engine oil above the full level mark.
- HINT:
- A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
- When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.
- If low quality oil or oil of an inappropriate viscosity is used.
- When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.
- When leaving the idling for a long time, or when driving frequently through heavy traffic.
| INSPECT ENGINE OIL QUALITY |
Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and oil filter element.
| INSPECT OIL PRESSURE |
Disconnect the oil pressure switch connector.

Text in Illustration *1
Oil Pressure Switch Assembly
*a
Oil Pressure Gauge
Remove the oil pressure switch assembly.
Install the oil pressure gauge.
Warm up the engine.
Measure the oil pressure.
- Standard Oil Pressure:
Condition
Specified Condition
Idle
29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
3000 rpm
160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi)
Remove the oil pressure gauge.
Apply adhesive to 2 or 3 threads of the oil pressure switch assembly.
- Adhesive:
- Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
- NOTICE:
- Do not let adhesive adhere to the oil hole.
Install the oil pressure switch assembly.
- Torque:
- 15 N*m{ 153 kgf*cm , 11 ft.*lbf }
- NOTICE:
- Do not start the engine for at least 1 hour after installation of the oil pressure switch assembly.
Connect the oil pressure switch connector.
Start the engine and check for engine oil leaks.
