2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait 5 minutes. The oil level should be between the dipstick's low and full level marks.
    If the oil level is low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill with engine oil above the full level mark.


CHECK ENGINE OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloring or thinning.

    Oil grade:
    0W-20, 5W-20, 5W-30 and 10W-30:
    API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil
    15W-40:
    API grade SL, SM or SN multigrade engine oil


CHECK OIL PRESSURE

  1. A102290E01
    Disconnect the oil pressure switch connector.

  1. Remove the oil pressure switch.

  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Standard:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or more
    3,000 rpm
    160 to 490 kPa (1.6 to 5.0 kgf/cm2, 23 to 71 psi) or more

    If the oil pressure is not as specified, check the oil pump.
    1. w/o Dual VVT-i:
      (Click here)
    2. w/ Dual VVT-i:
      (Click here)

  1. Remove the oil pressure gauge.

  1. G036762E02
    Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. Install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation of the switch.

  1. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.

← ON-VEHICLE INSPECTION (Oct 2014 – Dec 2014)COMPONENTS (Oct 2014 – Dec 2014) →