2014-2019 Hiace · Service Manual BODY ELECTRICAL

SYSTEM DIAGRAM

System information · Vehicles built from Oct 2014

B368695E02
B368696E02
B368697E02
B368698E02
B368699E02
B368700E02
B370294E01
Component
Function
Front door outside handle assembly RH/LH
Uses the built-in trigger switch to detect the operation of the front door outside handle assembly and sends signals to the certification ECU (smart key ECU assembly).
No. 2 indoor electrical key antenna assembly (front floor)
No. 3 indoor electrical key antenna assembly (rear floor)
Receives the request code from the certification ECU (smart key ECU assembly) and forms the vehicle interior detection area.
No. 1 indoor electrical key antenna assembly (front bumper RH)
No. 1 indoor electrical key antenna assembly (front bumper LH)
Receives the request code from the certification ECU (smart key ECU assembly) and forms the exterior detection area.
Electrical key antenna (rear bumper)
Receives the request code from the certification ECU (smart key ECU assembly) and forms the back door exterior detection area.
License plate light assembly
Uses the built-in trigger switch to detect the operation of the license plate light assembly and sends signals to the certification ECU (smart key ECU assembly).
Certification ECU (door control receiver)
Receives the smart entry and start system code/wireless code sent from the electrical key transmitter sub-assembly.
Combination meter assembly
Blinks the hazard warning lights when performing answer-back in accordance with commands from the instrument panel junction block assembly (body computer) sent through the combination meter assembly via direct line.
Wireless door lock buzzer
Sounds when warning functions operate in accordance with certification ECU (smart key ECU assembly) control.
Electrical key transmitter sub-assembly
Sends the ID code upon receiving a request signal.
Certification ECU (smart key ECU assembly)
Sends request codes to each indoor electrical key antenna assembly.
Distinguishes and verifies the ID code from the electrical key transmitter sub-assembly and sends signals to each ECU in response to operated functions (controls entire system).
Performs encryption code communication with the ID code box (immobiliser code ECU) when ignition operations are performed.
← PARTS LOCATION (from Oct 2014)SYSTEM DESCRIPTION (from Oct 2014) →