ON-VEHICLE INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT ENGINE OIL LEVEL SENSOR |
![]() ![]() ![]() ![]() ![]() ![]() |
Remove the engine oil level sensor with the connector still connected.
Measure the resistance when the sensor temperature is between 60°C (140°F) or higher.
Standard Resistance Tester Connection
Condition
Specified Condition
D11-1 - D11-2
Float position: top
Below 1 Ω
D11-1 - D11-2
Float position: bottom
10 kΩ or higher
- HINT:
- If the value is not as specified, replace the engine oil level sensor.




