ON-VEHICLE INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT CLOCK |
Disconnect the H20 connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E1 (H20-7) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
Standard Voltage Tester Connection
Condition
Specified Condition
B (H20-5) - Body ground
Always
10 to 14 V
IG+ (H20-6) - Body ground
Ignition switch ON
10 to 14 V
- HINT:
- If the value is not as specified, replace the combination meter assembly.
