2014-2019 Hiace · Service Manual BODY ELECTRICAL

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017

HINT:
  1. The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock control system is operating normally. Check the power door lock control system first before troubleshooting the wireless door lock control system (Click here).
  2. Use these procedures to troubleshoot the wireless door lock control system.


1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
      3. The following 5 items are important points for problem analysis:
      What
      Vehicle model, system name
      When
      Date, time, occurrence frequency, whether the problem occurred recently or has been occurring for a long time
      Where
      Whether the problem occurs at a specific location
      Under what conditions?
      Whether the doors were locked or unlocked, whether the engine switch was on, whether the engine has started
      How did it happen?
      Problem symptoms

    NEXT

    3.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      1. If the voltage is below 11 V, recharge or replace the battery before proceeding.
    NEXT

    4.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).

      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    A

    5.OVERALL ANALYSIS AND TROUBLESHOOTING
    1. Terminals of ECU (Click here).

    2. Operation Check (Click here).

    3. Diagnosis System (Click here).

    NEXT

    6.ADJUST, REPAIR OR REPLACE
      NEXT

      7.CONFIRMATION TEST
        NEXT

        ← HOW TO PROCEED WITH TROUBLESHOOTING (Jan 2015 – Dec 2016)OPERATION CHECK (from Oct 2014) →