REASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1.
INSPECT 2ND COAST BRAKE BAND ASSEMBLY
|
 |
- If the lining of the brake band is peeled off or discolored, or even if only a part of the printed numbers are corroded, replace the brake band.
- HINT:
- Before assembling the new band, soak it in ATF for at least 15 minutes.
| 2.
INSTALL 2ND COAST BRAKE PISTON |
 |
When the piston rod stroke is outside the standard value even if the brake band works normally, replace the rod with a new one.
- HINT:
- There are 2 different lengths for piston rod.
- Piston rod length:
Number of grooves
|
Thickness mm (in.)
|
0
|
78.40 (3.087)
|
1
|
79.90 (3.146)
|
- Install the washer plate, the compression spring and the piston to the piston rod.
- Firmly hold down the piston, then compress the compression spring.
Using needle nose pliers, install the E-ring.
| 3.
INSTALL 2ND COAST BRAKE PISTON OIL SEAL RING |
 |
- Coat the oil seal ring with ATF.
Install the oil seal ring to the piston groove, then snug it down by squeezing its ends together.
- NOTICE:
- Do not over-spread the ring ends.