2014-2019 Hiace · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT PISTON OPERATION OF OVERDRIVE BRAKE

  1. AT08451
    Place the overdrive support sub-assembly onto the direct clutch assembly.

  1. AT08149
    Apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) into the oil passage, and check that the overdrive brake piston moves smoothly.


INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

  1. D001246
    Measure the free length of the spring together with the spring seat.

    Standard free length:
    17.03 mm (0.6705 in.)

    If the free length is shorter than the standard free length, replace the overdrive brake return spring sub-assembly.


INSPECT OVERDRIVE BRAKE CLUTCH DISC

  1. AT06454E02
    Check if the sliding surface of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.

← DISASSEMBLY (from Oct 2014)REASSEMBLY (from Oct 2014) →