2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL OVERDRIVE PLANETARY GEAR THRUST WASHER NO.3

  1. AT08148
    Install the thrust washer to the O/D planetary gear with the groove side facing upward.


2. INSTALL OVERDRIVE ONE WAY CLUTCH

  1. AT04451E02
    Install the 2 retainer to the one-way clutch.

  1. Install the one-way clutch into the outer race with the flange side of the one-way clutch facing upward.

  1. AT01638E02
    Install the O/D one-way clutch and outer race to the O/D planetary gear.


3. INSTALL OVERDRIVE RETAINING PLATE

  1. AT08146
    Install the retaining plate.

  1. AT08135
    Using a screwdriver, install the snap ring.


4. INSTALL OVERDRIVE PLANETARY RING GEAR FLANGE

  1. AT08134
    Install the ring gear flange.

  1. AT08133
    Using a screwdriver, install the snap ring.


5. INSTALL OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08144
    Coat new O-rings with ATF, and install them on the O/D direct clutch piston.

  1. Being careful not to damage the O-rings, and press in the direct clutch piston into the clutch drum with both hands.


6. INSTALL OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. AT08145
    Install the piston return spring to the piston.

  1. Z004660E02
    Place SST on the spring retainer, and compress the return spring with a press.

    NOTICE:
    Stop compressing when the spring sheet is lowered to the place 1 to2mm(0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.

  1. Using a screwdriver, install the snap ring. Be sure the end gap of the snap ring is not aligned with the spring retainer claw.


7. INSTALL OVERDRIVE DIRECT CLUTCH DISC

  1. AT01639E02
    Install the 2 plates and discs.

    Install in order:
    P = Plate D = Disc
    P - D - P - D

  1. AT08155
    Install the flange with the flat end facing downward.

  1. AT08131
    Using a screwdriver, install the snap ring.


8. INSPECT OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08150
    Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.


9. INSTALL OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY

  1. AT08139
    Align the flukes of the discs in the direct clutch.

  1. Install the direct clutch assembly onto the O/D planetary gear.


10. INSPECT OVERDRIVE ONE WAY CLUTCH

  1. AT08138E03
    Hold the O/D direct clutch drum, and turn the input shaft. Check that the input shaft can be turned freely clockwise and locked counterclockwise.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →