2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL INPUT SHAFT OIL SEAL RING

  1. D025664
    Coat the 3 input shaft oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together, and then install them into the input shaft sub-assembly groove.

    NOTICE:
    Do not overspread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


2. INSTALL FORWARD CLUTCH PISTON O-RING

  1. D001365E02
    Coat 2 new O-rings with ATF, and install them onto the forward clutch piston sub-assembly.


3. INSTALL FORWARD CLUTCH PISTON SUB-ASSEMBLY

  1. AT08179
    Coat a new O-ring with ATF, and install it onto the forward clutch assembly.

  1. D001366
    While being careful not to damage the O-rings, press the forward clutch piston sub-assembly into the forward clutch assembly with both hands.


4. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D025660
    Install the forward clutch return spring sub-assembly.

  1. D025659E02
    Place SST on the spring retainer, and compress the forward clutch return spring sub-assembly with a press.

    NOTICE:
    Make sure that the end gap of the snap ring is not aligned with the spring retainer claw.


5. INSTALL FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC

  1. AT08177
    Install the cushion plate.

  1. C159058E01
    Install the 6 plates and 6 discs.

    Install in order:
    P = Plate, D = Disc
    P - D - P - D - P - D - P - D - P - D - P - D

  1. Install the flange with the flat end facing downward.

  1. AT08174
    Install the snap ring with a screwdriver.

    NOTICE:
    Make sure that the end gap of the snap ring is not aligned with the cutout portion of the forward clutch drum.


6. INSPECT PISTON STROKE OF FORWARD CLUTCH

  1. AT07843E02
    Using SST and a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    0.60 to 1.00 mm (0.0236 to 0.0394 in.)

    If the piston stroke is less than the limit, parts may be assembled incorrectly, so inspect and reassemble them if necessary.
    If the piston stroke is outside the standard range, select another flange.

    HINT:
    There are 8 different flanges in thickness.

    Flange thickness:
    No.
    Thickness
    mm (in.)
    No.
    Thickness
    mm (in.)
    90
    3.0 (0.118)
    94
    3.8 (0.150)
    91
    3.2 (0.126)
    95
    4.0 (0.157)
    92
    3.4 (0.134)
    96
    4.2 (0.165)
    93
    3.6 (0.142)
    97
    4.4 (0.173)

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →