2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. REMOVE REAR PLANETARY GEAR ASSEMBLY

  1. AT08197
    Remove the output shaft from the rear planetary gear.


2. REMOVE PLANETARY OUTPUT SHAFT OIL SEAL RING

  1. AT08198
    Remove the oil seal ring from the output shaft.


3. REMOVE REAR PLANETARY RING GEAR

  1. AT08199
    Remove the rear planetary gear from the rear planetary ring gear.


4. INSPECT ONE WAY CLUTCH NO.2

  1. AT08200E02
    Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locked clockwise.


5. REMOVE ONE WAY CLUTCH NO.2

  1. AT08191
    Remove the one-way clutch inner race from the rear planetary gear.

  1. AT08192
    Using a screwdriver, remove the snap ring.

  1. AT08193
    Remove the No.2 one-way clutch with the retainers from rear planetary gear.


6. REMOVE PLANETARY CARRIER THRUST WASHER NO.2

  1. D028060
    Remove the thrust washer No.2 from the rear planetary gear.


7. REMOVE PLANETARY CARRIER THRUST WASHER NO.1

  1. D028061
    Remove the thrust washer No.1 from the rear planetary gear.


8. REMOVE REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING

  1. AT08437
    Remove the 2 races and the bearing from the rear planetary ring gear.


9. REMOVE REAR PLANETARY RING GEAR FLANGE

  1. AT08206
    Using a screwdriver, remove the snap ring.

  1. AT08207
    Remove the ring gear flange.


10. INSPECT PLANETARY PINION GEAR THRUST CLEARANCE

  1. AT04459
    Using a feeler gauge, measure the planetary pinion gear thrust clearance.

    Standard clearance:
    0.20 to 0.60 mm (0.0079 to 0.0236 in.)

    Maximum clearance:
    0.65 mm (0.0256 in.)

    If the clearance is greater than the maximum, replace the planetary gear assembly.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →