2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL REAR PLANETARY RING GEAR FLANGE

  1. AT08206
    Install the ring gear flange.

  1. Using a screwdriver, install the snap ring.


2. INSTALL REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING

  1. AT08324E02
    Coat the races and the bearing with petroleum jelly, and install them onto the rear planetary ring gear.

    Races and bearing diameter:

    Inside
    Outside
    Race (A)
    28.5 mm (1.122 in.)
    44.2 mm (1.740 in.)
    Assembled Bearing and Race (B)
    27.7 mm (1.091 in.)
    44.2 mm (1.740 in.)


3. INSTALL PLANETARY CARRIER THRUST WASHER NO.1

  1. D028061
    Coat the thrust washer with petroleum jelly.

  1. Install the thrust washer No.1 onto both sides of the rear planetary gear.

    HINT:
    Make sure that the lug shapes fit into the cutout portions of the rear planetary gear.


4. INSTALL PLANETARY CARRIER THRUST WASHER NO.2

  1. D028060
    Coat the thrust washer with petroleum jelly.

  1. Install the thrust washer No.2 onto both sides of the rear planetary gear.

    HINT:
    Make sure that the lug shapes fit into the cutout portions of the rear planetary gear.


5. INSTALL 1 WAY CLUTCH NO.2

  1. AT02494E02
    Install the one-way clutch and 2 retainers into the rear planetary gear.

    HINT:
    Make sure that the open ends of the guides on the one-way clutch are facing upward.

  1. AT08192
    Using a screwdriver, install the snap ring.

  1. AT08191
    While turning the one-way clutch inner race counterclockwise, install the one-way clutch inner race to the rear planetary gear.


6. INSPECT 1 WAY CLUTCH NO.2

  1. AT08200E02
    Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locked clockwise.


7. INSTALL REAR PLANETARY RING GEAR

  1. AT08199
    Install the rear planetary gear onto the rear planetary ring gear.


8. INSTALL PLANETARY OUTPUT SHAFT OIL SEAL RING

  1. AT08198
    Coat the oil seal ring with ATF, and install it to the output shaft.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal ring, check that it rotates smoothly.


9. INSTALL REAR PLANETARY GEAR ASSEMBLY

  1. AT08197
    Install the output shaft into the rear planetary gear assembly.

← INSPECTION (from Oct 2014)PRECAUTION (from Oct 2014) →