INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
Using a dial indicator, measure the inside diameter of the oil pump body bushing.

- Maximum inside diameter:
- 38.19 mm (1.5035 in.)
| INSPECT STATOR SHAFT ASSEMBLY |
Using a dial indicator, measure the inside diameter of the stator shaft bushing.

- Maximum inside diameter:
- Front side:
- 21.58 mm (0.8496 in.)
- Rear side::
- 27.08 mm (1.0661 in.)
| INSPECT CLEARANCE OF OIL PUMP ASSEMBLY |
Using a feeler gauge, measure the clearance.

- Standard body clearance:
- 0.07 to 0.15 mm (0.0028 to 0.0059 in.)
- Maximum body clearance:
- 0.2 mm (0.0079 in.)
Using a feeler gauge, measure the clearance between the driven gear teeth and the crescent shaped part of the pump body.

- Standard tip clearance:
- 0.004 to 0.248 mm (0.0002 to 0.0098 in.)
- Maximum tip clearance:
- 0.3 mm (0.012 in.)
Using a steel straight edge and a feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.02 to 0.05 mm (0.0008 to 0.0020 in.)
- Maximum side clearance:
- 0.1 mm (0.004 in.)
There are 5 different thickness for drive and driven gears.
If the side clearance is greater than the maximum, replace the drive gear, the driven gear or the pump body.Drive and driven gears thickness: mm (in.) Mark
Thickness
F
10.690 to 10.699 (0.4209 to 0.4212)
G
10.700 to 10.709 (0.4213 to 0.4216)
H
10.710 to 10.720 (0.4217 to 0.4220)
J
10.721 to 10.730 (0.4221 to 0.4224)
K
10.731 to 10.740 (0.4225 to 0.4228)
| INSPECT OIL PUMP DRIVE GEAR ROTATION |
Make sure the drive gear rotates smoothly.

Remove the oil pump assembly from the torque converter clutch.
