2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL FRONT OIL PUMP OIL SEAL

  1. AT05154E01
    Remove the oil pump driven gear.

  1. Using SST and a hammer, install a new oil seal.

    SST
    09350-30020   (09351-32140)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the oil seal lip with MP grease.


2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY

3. INSTALL FRONT OIL PUMP DRIVEN GEAR

  1. D025800
    Coat the driven gear with ATF.

  1. Install the driven gear to the oil pump body.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

  1. D025799
    Coat the drive gear with ATF.

  1. Install the drive gear to the oil pump body.


5. INSTALL STATOR SHAFT ASSEMBLY

  1. AT08410
    Align the stator shaft with each bolt hole.

  1. Install the 13 bolts.

    Torque:
    10 N*m{ 100 kgf*cm , 7 ft.*lbf }


6. INSTALL STATOR SHAFT THRUST BEARING RACE

  1. AT08670
    Coat the thrust bearing race with petroleum jelly.

  1. Align the tap of the bearing race with the hollow of the pump body.


7. INSTALL CLUTCH DRUM OIL SEAL RING

  1. AT08409
    Coat the 2 oil seal rings with ATF.

  1. Squeeze the ends of the 2 oil seal rings together with the wrap distance 8 mm (0.31 in.) or less, and then install them to the starter shaft groove.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


8. INSPECT OIL PUMP DRIVE GEAR ROTATION

  1. AT08408
    Make sure the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter clutch.


9. INSTALL FRONT OIL PUMP BODY O-RING

  1. D025646
    Install the O-ring to the oil pump assembly.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →