2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE

  1. AT08451
    Place the O/D support assembly onto the direct clutch assembly.

  1. AT08149
    Apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) into the oil passage as shown, and check that the O/D brake piston moves smoothly.


2. REMOVE OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

  1. AT08158
    Remove thrust washer from O/D support.

  1. AT08444E02
    Place SST on the spring retainer, and compress the return spring with a press.
    SST
    09350-30020   (09350-07030)

    NOTICE:
    Stop compressing when the spring sheet is lowered to the place 1 to 2mm(0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.

  1. Using a screwdriver, remove the snap ring.

  1. Remove the return spring.


3. INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

  1. D001246
    Measure the free length of the spring together with the spring seat.

    Standard free length:
    17.03 mm (0.671 in.)


4. REMOVE OVERDRIVE BRAKE PISTON

  1. AT08249
    Place the O/D support onto the direct clutch assembly.

  1. AT08159
    Hold the O/D brake piston so that it does not slant, and apply compressed air into the passage to remove the O/D brake piston.

  1. Remove the O/D brake piston.

  1. Remove the 2 O-rings from the piston.


5. REMOVE OVERDRIVE CLUTCH DRUM OIL SEAL RING

  1. AT08160
    Remove the 2 O/D clutch drum oil seal rings.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →