2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL OVERDRIVE CLUTCH DRUM OIL SEAL RING

  1. AT08151
    Coat the 2 oil seal rings with ATF.

  1. Squeeze the ends of the 2 oil seal rings together, and then install them to the O/D support groove.

    NOTICE:
    Do not spread the ring ends more than necessary.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


2. INSTALL OVERDRIVE BRAKE PISTON

  1. AT01979
    Coat 2 new O-rings with ATF, and install them on the O/D brake piston.

  1. Being careful not to damage the O-rings, and press in the brake piston into the O/D support with both hands.


3. INSTALL OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

  1. AT01978
    Install the piston return spring.

  1. AT08152E01
    Place SST on the spring retainer, and compress the return spring with a press.
    SST
    09350-30020   (09350-07030)

    NOTICE:
    Stop compressing when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from bearing deformed.

  1. Using a screwdriver, install the snap ring. Be sure the end gap of the snap ring is not aligned with the cutout portion of the O/D support.

  1. AT08158
    Coat the thrust washer with petroleum jelly, and install it onto the O/D support.

    HINT:
    Make sure that the lug shape fits into the hole on the O/D support.


4. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE

  1. AT08451
    Place the O/D support assembly onto the direct clutch assembly.

  1. AT08149
    Apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) into the oil passage as shown, and check that the O/D brake piston moves smoothly.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →