2014-2019 Hiace · Service Manual TRANSMISSION

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT OVERDRIVE 1 WAY CLUTCH

  1. AT08138E01
    Hold the O/D direct clutch drum, and turn the input shaft. Check that the input shaft can be turned freely clockwise and locked counterclockwise.


INSPECT OVERDRIVE DIRECT CLUTCH DRUM SUB-ASSEMBLY

  1. AT08035
    Using a dial indicator, measure the inside diameter of the clutch drum bushings.

    Maximum inside diameter:
    27.11 mm (1.0673 in.)

    If the inside diameter is greater than the maximum, replace the clutch drum.


INSPECT PISTON STROKE OF OVERDRIVE DIRECT CLUTCH

  1. AT08140
    Place the oil pump onto the torque converter clutch, and then place the O/D direct clutch assembly onto the oil pump.

  1. AT04448E01
    Using SST and a dial indicator, measure the O/D direct clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    1.85 to 2.15 mm (0.0728 to 0.0846 in.)

    If the piston stroke is less than the limit, parts may have been assembled incorrectly, so check and reassemble again. If the piston stroke is outside the standard, select another flange.

    HINT:
    There are 8 different thicknesses for the flange.

    Flange thickness: 
    No.
    Thickness
    No.
    Thickness
    08
    3.8 mm (0.150 in.)
    04
    3.4 mm (0.134 in.)
    07
    3.7 mm (0.146 in.)
    03
    3.3 mm (0.130 in.)
    06
    3.6 mm (0.142 in.)
    02
    3.2 mm (0.126 in.)
    05
    3.5 mm (0.138 in.)
    01
    3.1 mm (0.122 in.)


INSPECT OVERDRIVE DIRECT CLUTCH CLUTCH DISC

  1. AT06455E01
    Check to see if the sliding surfaces of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


INSPECT OVERDRIVE CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D001246
    Measure the free length of the spring together with the spring seat.

    Standard free length:
    15.8 mm (0.622 in.)


INSPECT OVERDRIVE DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08150
    Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.


INSPECT OVERDRIVE PLANETARY GEAR ASSEMBLY

  1. AT08143
    Using a dial indicator, measure the inside diameter of the planetary gear bushing.

    Maximum inside diameter:
    11.27 mm (0.4437 in.)

    If the inside diameter is greater than the maximum, replace the planetary gear.

  1. AT04450
    Using a feeler gauge, measure the planetary pinion gear thrust clearance.

    Standard clearance:
    0.20 to 0.60 mm (0.0079 to 0.0236 in.)

    Maximum clearance:
    0.65 mm (0.0256 in.)

← DISASSEMBLY (from Oct 2014)REASSEMBLY (from Oct 2014) →