REASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL 2ND BRAKE PISTON |
Coat 2 new O-rings with ATF, and install them on the 2nd brake piston.

Being careful not to damage the O-rings, and press the 2nd brake piston into the 2nd brake drum with both hands.
| 2. INSTALL 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY |
Install the piston return spring.

Install the spring retainer.
Place SST on the spring retainer, and compress the return spring with a press.

- SST
- 09350-30020
(09350-07040)
- NOTICE:
- Stop compressing when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.
Using a snap ring expander, install the snap ring.
| 3. INSPECT 2ND BRAKE PISTON |
Make sure the 2nd brake piston moves smoothly when applying and releasing low-pressure compressed air to the 2nd brake drum.

| 4. INSTALL PLANETARY CARRIER THRUST WASHER NO.4 |
Coat the thrust washer with petroleum jelly, and install it.

- HINT:
- Make sure that the cutout portions of thrust washer fit into the teeth of the spring retainer.
