DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1. REMOVE REAR PLANETARY GEAR ASSEMBLY |
Remove the output shaft from the rear planetary gear.

| 2. REMOVE PLANETARY OUTPUT SHAFT OIL SEAL RING |
Remove the oil seal ring from the output shaft.

| 3. REMOVE REAR PLANETARY RING GEAR |
Remove the rear planetary gear from the rear planetary ring gear.

| 4. INSPECT 1 WAY CLUTCH NO.2 |
Hold the planetary gear and turn the one-way clutch inner race. Check that the one-way clutch inner race can be turned freely counterclockwise and locked clockwise.

| 5. REMOVE 1 WAY CLUTCH NO.2 |
Remove the one-way clutch inner race from the rear planetary gear.

Using a screwdriver, remove the snap ring.

Remove the No.2 one-way clutch with the retainers from the rear planetary gear.

| 6. REMOVE PLANETARY CARRIER THRUST WASHER NO.2 |
Remove the thrust washer No.2 from the rear planetary gear.

| 7. REMOVE PLANETARY CARRIER THRUST WASHER NO.1 |
Remove the thrust washer No.1 from the rear planetary gear.

| 8. REMOVE REAR PLANETARY FLANGE THRUST NEEDLE ROLLER BEARING |
Remove the 2 races and the bearing from the rear planetary ring gear.

| 9. REMOVE REAR PLANETARY RING GEAR FLANGE |
Using a screwdriver, remove the snap ring.

Remove the ring gear flange.

| 10. INSPECT PLANETARY PINION GEAR THRUST CLEARANCE |
Using a feeler gauge, measure the planetary pinion gear thrust clearance.

- Standard clearance:
- 0.20 to 0.60 mm (0.0079 to 0.0236 in.)
- Maximum clearance:
- 0.65 mm (0.0256 in.)
